Make it a component and save it to a component collection, then select and place it from the component panel whenever you need it.

https://sketchucation.com/plugin/2767-fredoconnect Something like this?

stl importer by Jim Foltz I'll give that a try. Thanks.

Thanks!

Depending on your model, Tig's Slicer5 will do that for you.

Here is the link to Fredo scale that has the inference to line. My install is not correct. Make sure you pay attention to his direction including LibFredo6 4.5 install. That will give the functionally you need. http://forums.sketchucation.com/viewtopic.php?f=323&t=17948&p=403999

Which panels? Most of them would be best modeled as a small section copied to make an array of the desired size. The panel called Causeway would be the easiest to do but I'll guess you're after one of the others. It would actually probably be best to create a seamless texture and insinuate the panels rather than using geometry.

I can't make my design a manifold solid I need help take one.skp

@unknownuser said: I am given the inside dimension, the arc height, the inner radius and the width (in this case, 44.25, 7.25, 37.77 and although in this instance it didn't quite work out that way. Thats because you have to use the inside dimension and height and calculate the inner radius or use the inner radius and calculate the inside dimension. So I guess the question is which one of these is the most important. The model referenced below shows the differences between the Arches using either the radius or the chord length. Arches by plugin Arches generated by plugin

Hi Gaieus I tried to upload again this morning. No luck again. Thanks for the instructions. Works fine now.

Maybe there Or there