Hello TIG
I am a real fan of your extensions.
2D I use every day. But 2023 release dose not allow to parametre lines, witdth and type.
Unless I am dumb, do you have a solution
Marc ANGLARET France

Hello
I explain this method because I did not find any precize answer, an it may help somebody.

SU PARAMETERS

• With use maximum texture size, you can go up to 4096*4096 with a good graphic card

PREPARING IMAGE

• coming from PDF, you can go from PDF with Photoshop to jpg, and save in 300dpi
• coming from DXF, you can use Inscape, but job is a little more painful

CUTTING IN IDENTICAL PIECES

• with photoshop (affichage, magnetisme, tranche) you get (selection de tranche)
• with right mouse you choose horizontal 3, vertical 4
• save to the web: you have your identical pieces in jpg

IMPORT IN SU

• first square OK, align all other to that one, compose the page
• get the highest dimension to scale

I get less than 0.001 error
It takes a quarter of an hour
Good luck
Marc

Hello
I work myself on a 4K, 40' monitor, with excellent satisfaction.
We sent back a 30' monitor where everything was unworkable due to tiny lines, icons...
the dpi is limited by windows and sketchup
To work in 5K, the actual need would be 50' monitor
Marc

Bonjour,
je viens de faire un plan de 60m * 25m sans trop de soucis

• perte de la logique au milieu du plan, difficulté de savoir pourquoi
• cotes ne reprenant pas les config de SU ou du modele
• difficulté de placer les portes dans les coins

Mais très intéressant

• la logique de création de modèles facile
• rapidité de travail
• rassurant car on est toujours sur SU et non pas dans une autre logique
• souhait d'avoir plus de composants dynamiques, tel que portes coulissantes, autres portes.

Par contre il semble que le créateur ait arreté de travailler sur le produit.
Marc
Architecte

Thank you cotty,
I have found that the fire wall had blocked
access to web for layout, and therefore the programm
could not start.
It is the same result with SU

Merci beaucoup
Marc

Hello
After an automatic restart from another programm, Layout does not work anymore, while SU8 is OK
I have tried the followings

• repair SU8 with original programm
• delete SU , restart and install again
• copy exe files (SU et LO) from another computer

None of these have worked.
If some one had an idea to repair, I would be very very thankful
Marc

Mitcorb
If I can give you my experience, don't save directly to USB unless your file is small.
Saving a 20mb file takes about 5 minutes directly to USB.

• last lacie creditcard usb 20Go hard disk got an electrical connection problem between disk and in-between system
• last esata usb "ram" 32Gb hard disk collapsed when pluging out without logical procedure
  Anssi advice is good.
  Marc

Hello

I am trying to get hold of fontsize according to scale and paper size.
I thought that size depended on size of paper but it does not.
On the following tests, size depends on framing. With the same scale and paper size you get different sizes according to part of drawing you have on your screen.

On 2 A4 size I get a different size if my drawing is partly or fully appearent
It is very annoying
Marc

Tiger

Thanks for help, but I am in decimeter precisiion 0; I tried all other units
with re-starting SU without success.
I tried hardware acceleration off too without results.

Marc

Another problem
Dimensions have blown out all over the sheet
Marc