Ahh! Perfect! Many thanks for that! You’ve saved me hours of searching and trying to figure it out on my own!

I appreciate your reply a lot.

Mark

It worked! Thanks!!

Jean Lemire you are a true Gem!

You have solved 2 of my head scratchers yesterday, and today I will be much more productive!! Thanks for the good help!!

Off to make a new wheel!

Mark

Hi Wo3Dan, hi folks.

I quitted SU then I changed my decimal separator from the . to the , and the list separator from the , to the ;

I restarted SU and it works.

I quitted SU and then I reverted back to the . and , and it still works ?!?!?!

Strange.

Anyway, problem solved.

The help is still incorrect unless I goofed somewhere.

Best regards.

There are scripts to 'flatten' geometry - if that's too draconian try using the Sandbox tools to Drape the edges down onto the surface a a large rectangle you've drawn below it so again then are coplanar...
A little more detail about this mess-up might help us tailor a better response ?

Yea TT Select Curve is great.
But I have come across a modeling request where I need it to continue selecting past an intersection. similar to a ring select.
Searching ....

ring selecting.png