If you have it set one way in your template it will be repeated in any new models made from that template, but if you change it in any model it's remembered in that model as a new setting. It is a very useful feature to toggle on/off as you work...

@thomthom said: Open the Styles window, Go to the Watermark section (fourth button from the right, big OK on it) Insert watermarks/backgrounds Thanks Thomthom! I found it. More details for those who may run into this problem again: After opening the Styles Window, clicl the Edit tab. The Watermark button belongs to the Edit section.

Jack, select your line then rigth click-->convert to-->polyline divider and set an interval. I suggest you to read the manual that comes with the plugin.

@xrok1 said: i guess you need to plan ahead next time . That's your right to guess.

Jackalvn I don't recommend using the tapemeasure tool 'trick' on the unedited escalator because the handrails etc will scale and be too low. Edit the escalator's group. The central parts of the escalator are 'modular'. You can remove perhaps the upper 7 of these. Then move the top part of the escalator down, snapping it onto the corner of the topmost remaining 'module'. At this point the total rise on the escalator is about 9mm too small for what you want [4200mm] - as it is made for use in feet-and-inches NOT mm. Now use the Tapemeasure tool and pick 2 points to match the vertical height of escalator as currently modeled [~4191mm ?] and immediately type in 4200; answer 'Yes' and the group will scale so the escalator's height is now 4200mm. The few millimeters difference on the handrail height and the steps is not significant for a SUp model.

thank you! I will try. Hope it works