Smit Panther ASD Tug

Mike Amos

"I can give you a specific rundown on this hull if needed"?

That would be really cool and helpful.

axeonalias

Step 1: Gathering info

So step 1 is to be sure you have decent drawings (Side View and Front view is a must, top view is a bonus), rib plans are always the best but in the case I had a fairly simple hull with enough information on the drawings to create it, of course go searching for the images of the real ship out the water if you can find any!

Step 2: Subdiv Mesh

Creating the subdiv mesh is always fun, in this case I hard a few hard chine lines to deal with so I was sure to mark them out, I should have added the keel in at this stage, it would have made for a better looking mesh but with higher poly count for no reason apart from a better looking mesh.

Step 3. Seperating mesh for smoothing

This step is really quite dependent on the type of hull you are creating, a wooden ship for instance will not need this, to preserve the hard chine when smoothing is applied, I separate the meshs in their smoothing groups so that when it goes to blender for mapping and smoothing, it wont smoothen out the areas near the bow and stern that have less than a 35° angle. the tradeoff with this method is you will have separated areas on the UV for something that is essentially joined.

Hope this helps!

axeonalias

The Exterior for the most part is complete, the text will probably be removed later and replaced with textures, the Poly count currently is at 438k

Currently 110 Hours 46 Minutes in

Mike Amos

Thanks very much for the TUT, looking fantastic.

Daniel

I'm blown away by your modeling. And inspired. Hardly touched SU in two years, but I'm starting to get the itch again.

Bryan K

Thanks axeonalias.

That was a good explanation of your hull modeling.

When you subdivide and smooth, what are you using?

axeonalias

Alright I dragged my feet abit with this one, but shes finally done, the lack of accurate info for the interior left me demotivated, but after the birth of my first son I decided, I better get this one out while he is asleep!, it still took another 3 weeks to complete the exterior but im happy with the result, im going to fiddle with getting it into VSF but I have my doubts, she has 53 separate 4k textures ( made up of Diffuse, AO, Rough, Metallic, Spec and normals ) so I have my doubts that VSF will be able to render her correctly

If you want to have a look at her in 3d, heres the link : https://skfb.ly/6WAyG

Sorry for the oversize images, just zoom out with your browser to 75% and you will see the whole image.