Drawing Conundrums

[gilles]

---

[TIG]

This one is slightly mored difficult.
But then try the one with the extra 'flap' shown dotted...

[Mike Lucey]

That was fast Gilles

I can imagine some hair pulling going on in the background with TIG's envelopes

[Gaieus]

TIG's is not possible if you want the fourth triangle, too. It is for the three of them.

[gilles]

I'm stuck with the extra lap.I'll give it a try later.

---

[TIG]

I know it's not possible with 4 flaps !
You'll always have a line left over that requires a re-trace!

I was being cruel

[TIG]

Here's the "5 rooms puzzle" The object of the puzzle is to draw a continuous [flat 2d] line that intersects each "wall" of the diagram only once. This example fails as the wall marked with the O is not intersected...

Officially it's "unsolvable"... but there is a tricky solution [that doesn't involve 3d or wormholes!]

[Roger]

Spelling Conondrum.

[Mike Lucey]

Cooldn't resist

[Mike Lucey]

Move just one matchstick to form a square!

---

Matches.skp

---

[Gaieus]

[Gaieus]

Make four, equilateral triangles of these matches.

---

---

4triangles.skp

[Mike Lucey]

I showed you that one when I was in Hungary

[Gaieus]

Nope. And anyway, how could you remember?

[boofredlay]

[Gaieus]

After all, this is a 3D application forum!

(The alignment could be nicer though... )

[boofredlay]

I should have just burned them.

[TIG]

Here's the solution to the 5-room-puzzle...
It relies on the interpretation that you can intersect a line [wall] at its very end point, thereby allowing you to intersect three at once...

[Mike Lucey]

Mmmmmm ...... 'end point'

[gilles]

Un peu tiré par les cheveux...