help with a thread
-
So what's your problem in trying to model it in SketchUp? What's not working?
@Leggy said in help with a thread:
there are only 4 crests on the thread
When you model it make it 2 or 3 turns longer so you can cut the extrusion off nicely. -
I’m the problem, ha ha
I need a back to basics tutorial, I always seem to miss a certain point and nothing happens . I can see the way both of you do the threads but I’m missing something -
with a 150mm diameter
-
ok , after watching Rich's video about 8 times I'm making progress. I was missing the upright extension
what's curve origin? I set it to -1.5 as in the video, so that made the male thread , now to make the female which ill offset by 0.3 -
@Leggy said in help with a thread:
I'm making progress.
OK. So you don't need the video tutorial I did? Good enough.
-
@Dave-R where is it?
-
@Leggy said in help with a thread:
watching Rich's video about 8 times I'm making progress
I did a video?
-
-
Aha I got you mixed up, that was the one I watched
-
I’m the problem, ha ha
I need a back to basics tutorial, I always seem to miss a certain point and nothing happens . I can see the way both of you do the threads but I’m missing something -
Ok I’ve managed a male and female thread on a 150mm diameter, with a 0.3 offset, . It’s very tight can wind it on for 2 threads , and that’s it. Tomorrow doing another female with an extra 0.3 clearance on all faces, so see how that goes. I think it’s the shrinkage on the printer that’s causing the problem
Thanks Guys for all your help -
@Leggy said in help with a thread:
I think it’s the shrinkage on the printer that’s causing the problem
That's probably it. You'll have to work that out based on the material.
-
I finally got it to work , pictures to follow , thanks Guys
-
-
-
Well done @Leggy
Advertisement