Medeek Wall Plugin

[TIG]

Is there a way to increase the size of the top-landing or intermediate-landings so that the nosings are one tread dim offset ?
That way the handrail turns properly - smoothly without a vertical drop.
Some localities' codes require the landings to be a tread or 300mm bigger than the stair's width.
Also extending the handrail a similar amount at the top and bottom is required...

Separately... the FollowMe twisting of the profile along complex paths is longstanding.
Extensions like Upright Extruder sidestep this; so you need to emulate those...

[medeek]

Version 3.8.1 - 01.02.2025

• Added additional sizes to the post module for steel square tubes.
• Updated the side spacer algorithm for stairs.
• Enabled wood grain texture for treads, risers, thrust blocks and stringers.
• Enabled a multi-board tread and spacing parameter for stairs.

[medeek]

@TIG The landings are not super sophisticated yet, mostly place holders. Still a bit of work to do on them.

The drop on the handrails (over-the-post) is fairly typical from what I've seen. I'm getting most of my reference material from ljsmith.com

[medeek]

Tutorial 59 - Multi-Board Treads and Side Spacers (7:15 min.)

[medeek]

Version 3.8.2 - 01.05.2025

• Added balusters to the stair module for vertical and OTP handrails.
• Added newel posts to the stair module for vertical and OTP handrails.

Tutorial 60 - Balusters, Posts and Handrails (16:39)

[medeek]

Version 3.8.3 - 01.10.2025

• Added a "deck" profile or option for handrails (with balusters) to the stair module.

Tutorial 61- Handrails for Decks (8:51 min.)

[medeek]

Version 3.8.4 - 01.14.2025

• Added a minimum winder depth parameter for all stair winder types.
• Adjusted the deck handrail algorithm for narrow cap rails (2x4).

[medeek]

Version 3.8.5 - 01.21.2025

• Updated the skirt boards to accommodate open treads.
• Added tread covers, carpet and stair runners for stairs, landings and winders.

[medeek]

Tutorial 63 - Stair Runners and Tread Covers (10:06 min.)

[medeek]

[b]Version 3.8.6[/b] - 01.25.2025

• Added tread covers, carpet and stair runners for T-shaped landings.
• Enabled the option for a single stringer (for modern style stairs).
• Added an option to disable the placeholder for landing/winder framing.
• Added a "GLASS" option for balusters within the built-in baluster materials.
• Added a "None" built-in option for the handrail profile parameter.

[medeek]

Tutorial 64 - Modern Stairs (12:43 min.)