@flatchoum said:

HI! I do have the same problem, can you tell me where to find this old version of the vray_SettingsRenderChannels.dll file? Since I don't get an answer from Chaosgroup, I'll have to try the other way to fix it. Thanks

Here are a copy: http://www.mediafire.com/download/hap0k3w50277wi4/vray_SettingsRenderChannels.zip

I contacted the author some time ago to see if he could upgrade the plugin and say to me: he is not involved in the project any more and he was on other matters.

I found this version of the plugin a few days ago and it works perfectly on SU 2015. Someone
rewrote the code.

http://www.sketchando.net/descargas/plugins/FerrariSketch1.1v2015.rar

Hola Gargon, creo que tu problema es, que en la computadora que estas usando como cliente, le pusiste el numero de serie de Thea y no la de cliente.

The Teddy bear, I guessed is a SNL product.....

Hey! Thanks, I put my fingers in the thermistor and change the value. Now, i am sure the thermistor is ok. I think it's going to be a software problem.

Hi Dukejazz, sorry for the late.

I messure the direct on the thermistor, a 100k epcos https://ultimachine.com/content/thermistor-100k and show me 95.2

Later, I messure at the end of the cable and show me 93.2

It's ok that numbers or or should show 100.

I read, in some place, that 90-95 should be a good lecture.

Also, I use other type of thermistor, (don't have espec for that kind of thermistor). When I connect the other thermistor (not the 100k epcos), Pronterface (aka Printrun) read 245C that also is not right

Many Thanks Dukejazz! I take a look to the links and comment to you later.

Regardas

Your post rock! Thanks for sharing.

Regards Pete.

@dukejazz said:

Hi Edgar
Thermistor mark 0 degrees mean no power to heating coils

Exact, the extruder don't heat

@dukejazz said:

bad switch from a driver lines or the feed data stream missing

use a volt meter to find the break ( you can eye in parts for melts signs or solder legs opens and ribbon cables can open up on you too.)

I already use a voltimeter for check twice the wires.

@dukejazz said:

did you have a software changes

Change PC

@dukejazz said:

software exporter for your machine may be limited

Any other software like Cura o Slic3r?

@dukejazz said:

sorry for the wait

No problem, thanks for your attention.

@dukejazz said:

check with RepRap Prusa

I already search in reprap forums but I can't solve my problem.

Regards

Hi, some time ago, I build a RepRap Prusa. Everything is ok until a few days.

I used to print with PronterFace and also use Marlin as firmware, but I get an error: the thermistor mark 0 degrees. Change the thermistor, check the wires twice, check the conections, twice also, and everything seems to be ok, but still gives me the same error.

Is any other software that I can use to print?

Thanks in advance. Regards,

Edgar