When setting a texture image size in sketchup is this done visually or do you use the jpg original pixel size?

Thanks in advance

Thank you most helpfull

I would like to have Sketchup model printed a1 Size at the printers. Would they need to have sketchup installed in order to print it? or do I have to save to a special format?

Thanks in advance

Simon

Thank you for all the useful replies & links.
I have been looking at Greek orders of architecture. The capital I have chosen derives from the Corinthian order, which apparently was not used as much as the others. So keeping with history I might have to go with a easier order

Looking around the web I have seen some really good examples, I was wondering if these were
3d scanned?

Hello Folks

I would like to model this pilaster capital.
I have imported the jpg into sketchup & tried tracing over the top using freehand, but I am not convinced this is the easiest way.

What would be the best way of going about this?

Thanks In Advance

Simon

Nice clock Dave,I love quarter sawn oak.

Thanks Dave I will give it a go.

Your right a smoother transition would be better, can you tell me how please?
The curve is at the front because the room that the table top was in was turned on it axes, if that make sense. I wanted to have the sun enter my room through a window without changing the time or date

Thanks Dave
It just worked for me i am not sure what I was doing wrong, but I am guessing probably not following your instructions precisely

Done

Cabinet top.skp