Guess what: that's not the entire ship. As said, that file is just the part isolated. The file size is because of those textures 😕

[EDIT] Yeah, it's the texture's fault. I resized it to 25% of it's original size and now it shows up just fine. I didn't know there was a max texture size that Kerkythea could handle 😕

Thanks! 😄

You can try this, http://www.nicetuna.com/kt2obj along with this, http://forums.sketchucation.com/viewtopic.php?f=80&t=35936&hilit=fluid+importer

Mike

Really nice 👍
What's your next project?

Bah, very annoying, I was hoping I could find it somewhere but it seems tha's not the case. >_<

A little while ago I had the same problem, and went for a shower. Point was.. it wasn't that big of an operation. SU5 did it without even twitching, while 7 wasn't finished with when coming back half an hour later. And as said, it was a pretty straightforward oparation: half a cylinder IwM to a flat surface.

It seems that for now, the problem has been solved: apparently an update was all it took to iron it out. Thanks anyway guys 😄

I've been tinkering with a NES Lite for some time now, this started a bit after I was trying to convert a NES into the Transformer charachter Soundwave. That, unfortunately, isn't succesfull up until today, but I plan on finishing it somewhere in the future 😛 The NES Lite, however, turned out pretty good, the design incorporating a removable power converter and all kinds of shiny stuff. Here shown with an original NES and a cartridge for size comparison. When the cartridge is slid into the NES Lite, it will become flush with the rest of the casing. I'm thinking of a lid that revolves back when you put the cartridge in, a la the old VCR players, but I'm not sure of that yet...

NES_lite.jpg