help with a thread
-
Are you trying to model a cap or the neck of the container? What is it exactly? I've been trying to find real specifications for the threads on screw top containers but based on what little information you've provided, it's been a waste of time.
-
this thread is a weird one . its on an Italian built mega yacht. its a 150mm diameter aluminum tube with a 20mm high thread on the end. the tube holds a retractable electric cable for shore plug in, when at sea the cable is retracted and the cap I have to make screws on the top to keep the water out
I"ll get some more info on the thread -
here is the profile and my measurements, there are only 4 crests on the thread
hope this helps -
with a 150mm diameter
-
So what's your problem in trying to model it in SketchUp? What's not working?
@Leggy said in help with a thread:
there are only 4 crests on the thread
When you model it make it 2 or 3 turns longer so you can cut the extrusion off nicely. -
I’m the problem, ha ha
I need a back to basics tutorial, I always seem to miss a certain point and nothing happens . I can see the way both of you do the threads but I’m missing something -
with a 150mm diameter
-
ok , after watching Rich's video about 8 times I'm making progress. I was missing the upright extension
what's curve origin? I set it to -1.5 as in the video, so that made the male thread , now to make the female which ill offset by 0.3 -
@Leggy said in help with a thread:
I'm making progress.
OK. So you don't need the video tutorial I did? Good enough.
-
@Dave-R where is it?
-
@Leggy said in help with a thread:
watching Rich's video about 8 times I'm making progress
I did a video?
-
-
Aha I got you mixed up, that was the one I watched
-
I’m the problem, ha ha
I need a back to basics tutorial, I always seem to miss a certain point and nothing happens . I can see the way both of you do the threads but I’m missing something -
Ok I’ve managed a male and female thread on a 150mm diameter, with a 0.3 offset, . It’s very tight can wind it on for 2 threads , and that’s it. Tomorrow doing another female with an extra 0.3 clearance on all faces, so see how that goes. I think it’s the shrinkage on the printer that’s causing the problem
Thanks Guys for all your help -
@Leggy said in help with a thread:
I think it’s the shrinkage on the printer that’s causing the problem
That's probably it. You'll have to work that out based on the material.
-
I finally got it to work , pictures to follow , thanks Guys
-
-
-
Well done @Leggy
Advertisement