LIGHTUP Help
-
This I did not know, thanks Adam, ill check it this evening to be sure but normally I only use png format images in sketchup, ill post to see if that is or not the issue
Ill check that also Gaieus just to be sure
-
@beginner said:
Hi iichiversii,
Can you post your model.
We have LU and maybe I could help.Thanks for the offer, ill try out what Adam suggests and if it isn't the issue ill post
-
Ok the texture was a png and it never worked, to double check i exported the image and converted to png to be sure and had the same issue, but i then converted to a TGA image and it works just fine, still cant understand why the PNG image didnt work
-
What software are you using to convert and make your images? Photoshop? GiMP?
-
Hi Chris, i use GIMP
-
Hmm, I'm not as familiar with that one. I know in photoshop for saving png it gives an option for Interlace - either none or interlaced. Typically none is what I always use. and probably make it an 8bit rgb mode png. That's all I've got. And I don't have lightup experience, just general png usage experience, so its just a guess.
-
Share the texture to remove the mystery
-
-
try this
-
Ok that worked Rich, so what was wrong with my PNG ? and what should i have done to make it work?
-
I want to know how you went about saving....
-
@iichiversii said:
Ok that worked Rich, so what was wrong with my PNG ? and what should i have done to make it work?
Perhaps what you've done is export the texture and done "save as" a PNG. Which converts it to a PNG file.
But the embedded Material texture you had before that went red (named "TREE(1).PNG") was actually a jpeg with a misleading extension.
but glad you've resolve it!
Adam
Advertisement