2D Fillet plugin - how to change number of segments?

TIG

I just tried it - it was OK - I can a 40 radius fillet between an arc and a line.
Make sure they are in the same context and coplanar... and that you pick the last segment of the arc...
Does it always crash or can you fillet two lines forming the corners of a rectangle ??

Because the fillet tool uses temporary groups during its creation process there are some rogue scripts that mess with native classes/methods [often involving groups - but usually making failures or errors rather than crashes] - e.g. SketchyPhysics, and some that add ill-advised observers that crash as the unrelated 'fillet' group is made/modified.
There is a 'quarantine list'... also some newer BIM tools use this kind of observer that breaks legit tool's operations and can crash.
Try using the SketchUcation 'Plugins Manager' to disable suspect plugins, restart SketchUp and retry the filleting.

As I say it works for me...

JQL

Interesting, I always used to use 2d tools fillet...

I'll try TIG's Bezier too!

Thanks and best regards,

JQL

gilles

It may fail (but no crash) according to the arc segment length, same thing in 3D with Fredo's Round corner.

2D fillet

Round corners

TIG

In that case try a second or third segment to fillet ??

gilles

Yes I know, but if you have lots of fillet to do it's becoming very tedious.

TIG

OR... make your arcs with fewer segments.
You can always increase the segmentation later

gilles

Pourquoi faire simple?

TIG

With fewer segments the arc's segments will be longer, and therefore it'll fillet OK at a radius smaller than the arc's segment length; then you can increase the arc's segmentation in Entity Info, provided it falls within the fillet end and it will still look right.