Catamaran
-
How I'm doing this:
I made three copies. The first one on the right is my baseline. As I make corrections, it becomes the new baseline and replaces the previous model.
The middle one is where I make corrections, based on:
The one on the far left where I test and find the problems.
Current issues are getting the bulkhead heights to line up exactly with the hull profile.
I intend to use Soap Bubble or Curviloft to skin the hull. At worst, hand connect all the lines to make the hull surface, like I did with the Nadesico.
-
Yep. Non-connected lines and endpoint alignments were the problem.
I ended up using Curviloft for each compartment.
After making sure the bulkheads were the exact height of the corresponding point on the hull profile, I erased the hull profile lines between each compartment one at a time and made a new line to ensure the endpoints were connected, then used Curviloft to skin. One section at a time.
The bow was tricky and required a lot of small arcs for Curviloft work. The tail still needs some fiddling, but it's nothing major at this point. I'll fix it pretty quickly.
The hull curve is not perfect, but if you didn't know, you can't tell. I'm good with this.... this time.
-
Oops. Forget the main shot.
-
Looking good so far
-
Thanks tuna!
-
Aft fixed. It looks a little off because of the visible lines, but it is correct. (later edit: it was not ) I have not ungrouped the Curviloft sections yet, but when they are ungrouped and merged, it will look better. I will wait until I am absolutely sure it is correct. I'm only 98% sure at the moment.
On to the main cabin in the meantime.
-
Coming along nicely.
-
-
Resetting my workflow.
-
Definitely proceeding nicely mate.
-
-
OK, going to check all lines before I got further.
-
Stern fixed! (again it was not ) Took some fiddling and finessing even with Curviloft.
-
And dang it, it's still off by just a hair.
But I see how to fix it.
-
Fixed. The curve and slope are now correct
-
Nice..this is coming along!
-
Thanks marked001.
I've been a little under the weather, so I've just been doing easy renders. Can't focus on the hard stuff right now.
The weather swings in my region are making me... groggy? We are seeing 40F swings in very short periods.
-
@bryan k said:
The weather swings in my region are making me... groggy? We are seeing 40F swings in very short periods.
Yep, one day you need a parka and the next you need a t-shirt
-
Excellent progress
Side note…. I get the feel bads from the weather swings also. It’s been jumping around pretty bad lately here in north Texas
-
Thanks tuna.
Yeah, it's too much for me.
Anyway, roughing in the lower central deck hull. Next step will be to rough-in the aft deck.
Advertisement