Follow me into different radius
-
Sorry, says the file is to large, changed it down and still wont go through
Thanks for your patience -
Hope this helps
-
Since you seem to be having problems adding an Image, is it this sort of thing you are after?
-
Yes but a radius in the corner where they meet, so it blends through
Thanks for your time -
It can be done manually but it's much easier with Curviloft and Joint Push Pull.
One little note here, By using the center inference and magenta the small radius will be half the large one.
-
Genius !!!!!!
Thanks so much, you make it look so easy
-
It's only genius if it is clear enough for you to follow, otherwise it is just speed modelling which isn't very helpful.
There are various other ways to do something similar depending on the actual result you need. If needed you can still add an image as there may be a better option.
-
No that was perfect
I had curviloft on my old pc and forgot all about it
Thanks alot -
hi im getting this message
-
-
@leggy said:
hi im getting this message
For Curviloft to operate correctly, you need to select only the external contours, not the inner corner edges. Watch the short video by Box again.
Fredo
-
Aha ok thanks for that ill try again on Monday
-
For a bit of clarity, in my gif you see me select all of it and show that it doesn't work as it highlights too many edges, then I hold down shift to deselect the corner faces. You could also activate the tool with nothing selected and just click on the edges you need.
-
hi I followed your example and got this, any ideas
thanks so much for your time
-
Why don't you upload the SKP file so we can see what you started with?
-
-
Does the white one look more like what you want?
-
exactly, is it to do with the order you pick the lines?
-
No. The bottom arc has 24 segments so I divided the straight lines on the sides and top so there is a total of 24 segments up each side (including the segments in the arcs at the top.
-
how did you do that?
Advertisement