Stretch a roof

fbo_bern

yes, not bad. thank you....

rickgraham

Here's my attempt. I simply used the from contours from the Sandbox tools. Probably not what you envisioned tho...

Rick

rickgraham

Here's my attempt. I simply used the from contours from the Sandbox tools. Probably not what you envisioned tho...

Rick

DEFINATLEY not as Gai's looks SO much better.

Rick

brookefox

Trying to do it myself produces nil.

Weld to make a continuous curve is inconsistent but works on parts, either quarter, half, or whole without the crossing ribs, but soap timeouts (Timelimit finished!)!

brookefox

You work cheap, and fast, and well, Gai...

Thanks for being here.

chrisjk

Here is my attempt using TIG's Extrude edges by Rails. I have only done half as a demonstration. I think it works better for the corner with the straight edge although the other quadrant could be a bit smoother - perhaps by altering the number of line segments?

sonnendach.skp

dylan

I did it also with TIGs EEBR and it worked very well. I have not posted it because it left a slight valley down the centre when I mirrored the half and I guess that is not required.

Edit: Thought I may as well post the skp!

sonnendach.skp

massimo

@unknownuser said:

...but soap timeouts (Timelimit finished!)

You can download a new version that works until 10. October 2010.

brookefox

@massimo said:

@unknownuser said:

...but soap timeouts (Timelimit finished!)

You can download a new version that works until 10. October 2010.

Thank you. I needed a translation!

TIG

Making the profiles [and rails], each with the same number of segments gives best results in EEbyRails - to weld complex sets of arcs/edges into one curve first select all and explode back to plain edges - they stay selected then use 'weld' to join them...

brookefox

Thanks, I'll try to remember these tips.

@tig said:

Making the profiles [and rails], each with the same number of segments gives best results in EEbyRails - to weld complex sets of arcs/edges into one curve first select all and explode back to plain edges - they stay selected then use 'weld' to join them...