Thank you Cotty, I did it, now it is perfect!

How can I do that? I can not choose either at downloading, installing or starting the program. I am the administrator and only user of my computer.

I have reinstalled and installed 5 times everything. I made "housekeeping", now I have free space. But I get this warning anyway all the time. I can continue use Sketchup, it is only irritating. I have not installed any plugins, I did not installed or saved any other folders, it is a brandnew Sketchup Make. Have you any more advice?

Is there any solution?

Excuse me, not "maps", I mean folders.

Is it possible that I get this message because of my hard disc is almost full?

It is default, full permissions, I did not change anything. I have not any other maps, I did not use this version yet. I had Sketchup 8 before, but I used it very infrequently.

I get all the time this warning: "Unable to update the evaluation time. Make sure that C:\ProgramData\SketchUp 2013\SketchUp13If is writable". First I could open it, I saw that it was not ticked anywhere to make it unwritable. Now I ticked it somewhere to make it more available. I don't remember where, and I am unable to open this file. What can I do?

Thank you, Shepherd, I'll do so.

I had an older Sketchup, now the new is installed and it works! Thank you!

Now I made the arch in the component. According to the tutorial I could push it up easily, but I can not.

training4.skp

I don't understand. The tutorial http://www.youtube.com/watch?v=Kc0yunYvM7U
Look it at minute 9'40"

Thank you, Shepherd. I did undo arch, selected the component with doubleclick and tried again with pull-push. I see when I hover the arch and now in the component on both side, but I can not push it upwards. It will be a horisontal pushing.

Why I cannot push up the arc, according to the basic training video 4 tutorial?

training4.skp

I just make the little nice table in video 4 for beginners, and I have the same problem with snapping. I made the guides for the legs, and the rectangel jumps over the guide, regardlessly if I tick snapping or not. What can I do?

Sorry, it doesn't work for me. I have the first window ready, saved yesterday. Now I have 1 fine window and 2 rectangels. I wish to make the 2nd window according to the tutorial. I have the 2 lines from midpoint to midpoints. If I only hover over the 2nd rectangel, I don't get it in the other.

How is it possible to repeat the offset if I don't make it immediately after the first one? I follow the tutorial http://www.youtube.com/watch?v=ZwJntmJxi78 and I can not make the 2nd window in the 4th minute.

I follow the basic tutorial video 3 for beginners on this address: http://www.youtube.com/watch?v=ZwJntmJxi78
I had no such problem before this. I try to draw the offset-frame windows and the frame jumps up. I type 0,2 to get it normal.

It is not possible to push/pull smoothly, however Enable length snapping and enable angle snapping is unticked in Model info. I had no problem with this before.

Thank you, I know now. I select the face I will repeat, choose Offset tool, then Select tool, select the other face, change back to Offset-tool and double click on that face. My misstake was that I did not change back to select tool. before double-clicking.