3D Printed Screw Threads
-
Another little planer jack to add to the collection.
-
More screw threads. The nuts and bolts are threaded 8mm.
-
Dave , your mechanical bits never cease to amaze and delight me.
-
Thank you sir.
-
More screw threads. These are 23mm long.
They are for a model of a U-joint from around 1900.
The center ball and short pieces of the shafts have been printed. Yokes are printing now. Looks like I managed to get the screws dirty fitting them into the holes in the ball. I haven't decided it I'll print the tapered pins or make them a different way.
-
@tuna1957 said:
Dave , your mechanical bits never cease to amaze and delight me.
I agree with tuna57 completely.
-
Thank you.
-
Finished except for the tapered pins.
-
Nice
-
klasse!
-
Hey this is awesome, just a quick question. What do you typically use for tolerances between the nut and bolt? I know it depends on the printer but just wanted to get a baseline idea.
Robert
-
Thanks.
@rspierenburg said:
What do you typically use for tolerances between the nut and bolt?
I nrmally model the internal and external threads to the specifications given for the thread type and class. In some cases if I'm feeling lazy, I just scale up the internal threads by 1.02 or 1.03 in X and Y without scaling Z. I've found I can't be lazy with Acme and square threads, though. Scaling doesn't work for them. They have to be modeled correctly.
-
M6 x 1.0 screws. I didn't have any short enough metal ones on hand and it was faster to print a couple than go to buy some for this proof of concept thing.
-
-
I'd find it hard to resist the urge to hit that with a heat gun to smooth it out.
Crazy accurate modelling. Does it hold a seal?
-
I would like to do something to smooth it out but it's fine as it is. The threads have a fit typical of metal ones but it won't whistle. I think because the PLA doesn't resonate like bronze, brass, or iron would.
I expect I could run steam through it. Once.
Advertisement