3-in one window

[Epix3D]

How would you go about to make this kind of window?

[halroach]

Hey Epix,

It's not a total super convenient solution yet, but you can combine windows like in the following video:

[HornOxx]

hi - I'm not sure it's what you're asking or looking for.
Usually I use my own standard window components. I have optimized these windows a bit for my own following rendering process. If I have to, I vary the thicknesses of the mounting frames and the opening frames or any othe detailing. These window components I copy-paste then into the already done simple self-cutting opening components...

---

---

Window.skp

[Epix3D]

@halroach said:

Hey Epix,

It's not a total super convenient solution yet, but you can combine windows like in the following video:

Thank you Halroach. I knew I´d seen this video before. Just what I was looking for

[Epix3D]

I have another question..
Is it possible to adjust lenght/widh of sill beyond the interactive click length?

[halroach]

@epix3d said:

I have another question..
Is it possible to adjust lenght/widh of sill beyond the interactive click length?

Yes, of course!

1. Look for the setting: "(Interact Tool) Protrusions 0 Or"
   This will extend the sill to the sides. If it doesn't extend to the new length, use the interact tool once or twice to get it to extend again.

2. You can change how the sill extends outward or inward with the "Out" and "In" settings - Note that for the sill to be correctly positioned so that it is flush with the wall when In and Out are set to 0, you must set the "Wall - Thickness" so it matches the wall you are placing the window on.

[Epix3D]

Super Halroach! Actually I allready found/tested that setting but did not click interact twice.