Twisted Dovetail
-
if memory strikes right , the late Tage Frid shows how to layout , cut and fit this joint in his book " Tage Frid Teaches Woodworking" . Hope to give it a try just for grins one of these days.
-
I had the pleasure of watching Tage Frid handcut dovetails once years ago. He came to speak to a college woodworking class I was in. We watched as he laid out and quickly cut a set of dovetails. When he was finished, he put the joint together and then he looked around the room. Not at us but at the walls of the shop. The professor asked him what he was looking for and he replied, "A dovetail hammer." No one in the class including the professor ever heard of a dovetail hammer before. Frid broke into a smile and walked over to the hand tool wall and grabbed a claw hammer. He walked back over to where he'd been working and gave one of the pins a few whacks to spread out the fibers and fill a small gap he'd created when cutting the joint. Then he held up the hammer with a grin and said, "This is a dovetail hammer."
-
-
They slide in/out on the diagonal ?
-
No.
Radial.
.skp is up.Robert
-
@robertwan said:
Ipossible?
ha. wow.. at first i was thinking "ok, there's no way that's going together.. especially getting all 4 pieces to do it"
but, after checking your .skp, it appears like it will actually work.
-
It could be a challenge to create a jig for cutting that one accurately!
-
I made on the CNC.
Robert
-
Nice and clever!
-
I tried on the CNC, but it can not be done. The test is .skp file above.
Robert
-
@robertwan said:
I tried on the CNC, but it can not be done. The test is .skp file above.
do you mean it can't be done with CNC or it can't be done at all?
-
Chisel can be done.
I'll try to draw it later, it looked as if made on CNC.Robert
-
It's not bad, I thought there would be more problems.
That's what it looks like when made on CNC, there are few problems.
1-6 can be corrected with a chisel. 7 and 8 is an empty space, but invisible.
There's only 7x7x7 [mm] to cut out with a chisel.Robert
-
are you going to cut one?
-
Minimum of two pieces.
Robert
Advertisement