Tools on surface not working
-
I may have found part of the problem. I went through each tool and checked out everything in each context menu and it looks like my computer has something backwards or scrambled. This is a long and a bit confusing, but here goes:
When “Group” and “Mark With Construction Points” are being used, it says [GROUP] [CPOINT] by the "Show Instructor" button. When they are not being used, nothing is shown on the bottom.
"Trigonometric sense" will say yes or no. It is the only one that does that shows both on my computer
All others are the opposite and show nothing when they ARE in use, and show [NO…. when NOT in use].
These tools: Rectangle, Polygon, Circle, Ellipse, Parallelograms, 3 Part Circle, and Arc - all have the same discrepancy with their context menus.
With context menu item “Generate Faces”, the context menu shows:
Generate Faces (current=Yes) -->F8
The bottom shows: [GEN. NO FACES] and nofaces are generated.
*******I know that an arc can’t have a face because it isn’t a closed loop, but I thought I’d mention the discrepancyWhen the context menu shows:
Generate Faces (current=No) -->F8
There is nothing about faces listed on the bottom and faces are generated.With context menu item “Generate Curves”, the context menu shows:
Generate Curves (current=Yes) -->F8
The bottom shows:[NO CURVES]When the context menu shows:
Generate Curves (current=No) -->F9
There is nothing about curves listed on the bottom.I don’t know what “Generate Curves” actually does, so I can't tell if it is working or not, but I'm assuming that when the context menu says "no" it really means yes, as with the other tools.
The protractor only works with the Line and Sector tools
It does, however, show in context menus of all tools, whether they are supposed to have it or not.There isn't anything about it by the instructor button whether it’s on or off, even with the tools it does work with. Has anyone had any problems like these?
KJ
-
hello, I have a model with many polylines and the line tool doesn't work... is there a trick?I have a model with many polygons, and the line tool isn't working... is there a trick?
It can't isolate these faces; I've also tried showing the hidden geometry. Sometimes it works, sometimes it doesn't.
Krass
-
ce serait tellement bien si ça pouvait marcher un jour....
-
@Krass said in Tools on surface not working:
the line tool doesn't work
Can you expand on this? Is it that the enclosed area is not selectable?
-
yes, i need to paint high poly surfaces, hard edges painting, but no way
-
no this zone is not selectable as it should
-
SketchUp has limitations healing edges when they are below 1mm. Are you encountering that limit?
If yes, scale the object 10 - 100x and try drawing.
-
yes you are right! I forgot to scale the object... But at the end, I did it manualy
-
I enlarged it by a factor of 100, but it doesn't work.
-
Actually, it works better; I tested it elsewhere and the rectangle isolated the face well.
-
In 90% of edges not healing or holes not filling or missing it is edge size.
If you are importing scans it is best to x100 the scale to avoid this behaviour.
-
I often work with a scale of 1000x. I can treat millmeters as meters that way.
-
The simplest way to deal with many errors, imho.
Advertisement