The "Duh!" thread (aka the Doh! thread)
-
you should have a group hug
-
-
why thank you Box
-
-
no, if components hug you get a scaling issue
-
Groups, components or unique's doesn't matter! If you lot get close enough to be hugging there will be dubious 'plugin' accusations. As Rich says, there is a front door and a back passage...........
-
Everyone know that deep down, groups and components are the same.
-
-
So... are we starting chapter 2? Will it be a trilogy?
-
@jql said:
So... are we starting chapter 2? Will it be a trilogy?
It's been a love/hate project I've tackled on and off when I had time.
So to finally draw a line under it is great.
Now to see what happens next....
-
-
Are you bringing these to the Basecamp?
-
-
Nobody, I'm just wondering
-
I'm not bringing them. But they could be there.
-
You're not coming?
-
I like to place section planes at specific locations. So, when I learned that if I hold down CTRL before clicking to locate section plane, it will stick to the face it is near. Then I move the plane using the move tool relative to that face. Duh or D'oh, I don't know, but I like it.
-
Hey, everyone! I just downloaded the book. Thank you for the good memories!
-
Great book....love it....!!
Well done.
-
I found a small miss type on The D'oh! Book P61(ver.1.0) P63(ver.1.1)
[20mm, 10mm, 30mm] absolute move -> <20mm, 10mm, 30mm> relative move
By the way I could find Doh about Array Command, we can change operation 'x' to '/'
with using 'x1' , or we can change '/' to 'x' with using '/1'.copy(move + 'alt') some object and type VCB
<1000,,>
x4
10000
x1
/4
20000
/1
<1000, 1000, 1000>
x10
.... we can continue 'x', '/', distance value, relative vertics, absolute vertics.
'x1' or '/1' is important.Thank you for GREAT BOOK!!
Advertisement