Trouble undoing a joint push pull command
-
I have a model with lots of faces (less than a hundred) which i need to jointly extrude. i run Joint-push-pull and while the preview is almost real-time, the process took so long to complete. But when I wanted to undo the command (which is supposed to be one command). It simply wont undo and therefore messing up my geometry. Wish there's a better way to do this.
-
I think if you found a limitation or error in using JPP you should probably mention it in the JPP thread so Fredo can respond to it.
-
Also make sure you have the Outliner window hidden or shut down before you use JPP. It will slow down JPP to a crawl if open.
-
@cuttingedge said:
I have a model with lots of faces (less than a hundred) which i need to jointly extrude. i run Joint-push-pull and while the preview is almost real-time, the process took so long to complete. But when I wanted to undo the command (which is supposed to be one command). It simply wont undo and therefore messing up my geometry. Wish there's a better way to do this.
Well, difficult to tell without seeing the model and having something reproducible.
In any case, this is not intended and would be a bugFredo
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
Advertisement