Sandbox tools
-
oh wait, that's the same on a mac too..
i forgot about that part..ha(and, i can't remember if sanbox is turned on or off in the extensions by default?)
-
I think it's off by default Jeff, but not 100%
-
Hi everyone.
I want to write my problem on this title.
I have a problem with Sandbox.
I creted my land with your help. I want to put my building to the levels.
I know, we use "Stamp" for putting building on levels. But I didn't write numeral value for determine the building how much deep or up.
How can regulate that.?
Thank you. -
Push/Pull the building up/down. Perhaps leave it a little higher/lower than you intend it to be finally [depending on whether it is to be built up or cut in]... Afterwards you can always Select the building AND its flat stamped area (you can vary the offset of that flat area at the time of stamping by typing a new distance into the VCB) and by then using the Move Tool on this Selection: constrained vertically (blue) with Shift-key: then all connected geometry like 'embankments' will adjust their angle to suit...
-
Thank you Guys,
I have done it this way before-didnt work. When I wrote you...made it again-it worked
You are magic Guys.
Thanks a lot,
Have a Good one.
Kat -
@tig said:
Push/Pull the building up/down. Perhaps leave it a little higher/lower than you intend it to be finally [depending on whether it is to be built up or cut in]... Afterwards you can always Select the building AND its flat stamped area (you can vary the offset of that flat area at the time of stamping by typing a new distance into the VCB) and by then using the Move Tool on this Selection: constrained vertically (blue) with Shift-key: then all connected geometry like 'embankments' will adjust their angle to suit...
Thank you but I dont understand generally.
Can you explain with pictures... ? -
-
Is there a way that i can use scratch tool with irregular shape instead of the rectangular shape? say a star for example?
-
-
ohh... thanks a lot Gaieus!! This one's a great tool!
Advertisement