I use sketchup in interior design and spend most of the time building kitchens, work is a daily procedure which I hardly change lately, but I spend that much time importing and looking trough libraries to get the components...

I decided to get into DC's so that I'll work on that one dynamic component until it fills my needs...

I'd need some expert advice though, the 'children' that I resize get their position scaled too, and I could not figure out how to keep them in the exact XYZ...

any help ?

I'll attach the DC, I know whoever is gonna help is going to ask that

ps: I work with Italian, so terms and labels are not English

base.skp

I see these posts started in 2008... its 2012 but I give it a try

I'm using sketchup in kitchen-design on a daily basis, and the thread reveals your knowledge with sketchup...

I'd have a question or two for you, kind regards gerry