Hi,
Using the round corner plugin, I can not seem to put a radius corner on the inside radius of a hole cylinder. i.e a tube with out it filling in the end.
I can do the outside radius ok. However will not do the inside radius. I just want to remove that 90 deg sharp angle for the "hole" in the cylinder.
Any ideas?
Hi, the round corner extension via the fredo6 library all of a sudden seems to now make holes and adds black lines. As it was working I figure I've upset something somewhere.
Make a cube 14mm long, 4mm wide, 4mm high.
Run round corner across a 2 top 14mm edges, 2 vertical 4mm edges, and the intersecting horizontal edge.
Choose a 1mm round.
What I end up with is nice round edges on the straights, but the intersecting corners holes. See attachment.
What I am doing wrong.