@dave r said:
@littletux said:
Thanks for your answer, I will Try.
It is just a problem with curviloft.
What is the problem with Curviloft?
I scaled the model up like I told you to do, traced out the lines you provided, and ran Curviloft. I got this. Then I copied the geometry to make the opposite side.
[attachment=0:1n0wfs85]<!-- ia0 -->Screenshot - 10_29_2018 , 7_09_28 AM.png<!-- ia0 -->[/attachment:1n0wfs85]
Hello
thank you,
You are a boss the form seems to be perfect. Good job you say like this in your country.
I tried to scale the problem and the same.
there are holes in the surface. I do not know if it's normal.
I spent my whole day. I saw many video on sketchup today. I am very tired.
Ok let's say it's normal, I used FFD to change the shape a bit but it does not work and i don't really if is it the right plugin for to do that. Do you think that if I use Fusion 360 it will be easier?
Once the outside finishes I have to empty the inside and put a wall of 2mm. put a wheel arch.
I do not know if I have to buy a 3d printer. I think my level is just good for 3d square form, but as far as spehere is concerned it's too hard.
There is not much tutorial for shapes like this.
I tried fusion 360 but it seems harder for me.
After I have to do the cookpit window. I must also make the engine cover of the plane.
I really think I'm going to hang all my horses.
thank you for spending your time
Really
Bye see you later