Dear Tig,

what do you think about implementing the possibility to select a single line as well for the profile and not only a curve.
This would be very helpfull for the creation of complex models like cars for example. In such cases the division of the line in two segments is really undesired and would generate too many poligons.

Ionandre

Ok, now I have clear how it works. thanks.
Best option for me is to divide polygons in two welded halves. It doesn't take too long.
Moving profile can be an option for a different result. I mean the extrusion is good but with a different form.
By the way for what I have experimented until now, the last version (3.0) of the weld tool always work for me. I did notice some problem only with old version of this plug-in.

@tig said:

It takes the nearest points of the rails to place / adjust the profile.
Split the square's edge nearest the circle at it's center.
It should then not twist ?

Thank you for the advice, however It seems no possible.
By the way I can ever achieve the good result with the previous method.
Maybe it would be nice an option to set the starting point.
It could work well in conjuction with tool on surface I think.

By the way I think your plugin is quite revolutionary.

thanks again.

Ionandre

Just noticed this:

with a simple straight line(curve) used as profile you can loft 2 closed rail curves directly (poligons) as well, but if use an arc as profile the result is a twisted loft. Why that?

Hey this plugin can also make very good lofts by rails

It's Fantastic!

It works also on 3 closed curves.

Thank you so much

Hi Guys,

thank you all a lot for the feedback

tapermaker is even better than what I had in mind & Personally I think this could be added even in the must have plugin.

Hi All,

I was wandering if there was a "follow me & scale" script that permits you to increase or decrease the scale of a shape along his extrusion path.
Anything similar already exhisting?

thanks for any feedback