@dave r said:

What are the dimensions of the original before bending?

Very small, 2mm * 5 mm rectangle, extruded to 5mm.
I just tried to reproduce it after a restart but couldn't. Will post back when I have a consistent way to reproduce this. Same dimensions work fine on a clean slate.

Lovely plugin. Another issue: Sometimes when I do a "radial bending by selection of plane" I get some missing faces on the bending side.
PS: I restarted sketchup, and I cannot reproduce this anymore. Perhaps I set something in Fredolib somewhere during an operation.
See image:

Ouch, thanks Cotty. I guess it will be better to "explode" all of the components in that case in a final model file.

Hello,

I have some overlapping or touching components that I wish to 3d print. Do I need to intersect ("intersect faces") them, or it does not matter at all when it comes to printing the design?