Thanks to all for the speedy replies. Appreciate the free knowledge this forum has to offer.

Hi all. I cannot for the life of me figure this out. I would like to make a hole throught the body of this group by means of subtracting the pin group. I understand the body must be a solid but cannot fathom out how to make such. Have highlighted the axis in colour and can identify the non axix areas. How can I rectify this situation please. Perhaps subtraction is not the way to go. Many thanks

Router Neck.skp

Thank you so much for your swift response. That worked a treat. Wish I had come accross this forum eight hours ago. Regards

Attached file. One sketch has a completed correct bevel, the other to the right is incomplete. It is a wall tile 24.7cm square and 0.7cm depth. If you complete the bevel using FOLLOW ME this is the result. Incomplete bevel top right corner hollow. Can anyone assist please as it is doing my head in. Regards

Tile.skp

Tile.skp