Posts made by bpjmarriott1993

Hey guys

I've started building a wall (which I know nothing about) in SketchUp and I was hoping someone could just check it out and make sure everything is as it should be before I go further.

Some notes about the wall:

• The total height of the wall is 10'2" (2" more than I need)

• The red section marks out the chimney breast. I needed equal space on both sides.

• All timber is spaced at 24" on centre

• It is a load bearing wall

Question 1: Is anything missing or do I have an excess of anything?
Question 2: The fireplace comes out a further 4" do I need to add framing for that?

Thanks,
Brandon

Hi guys,

So I'm starting a new project and I need a little jump start. I've linked a couple of images and I was hoping someone with experience could estimate

• floor to ceiling height

• height and width of the door frames.

Note all doorways on the first image are different sizes. The right doorway (also seen in image 2) is slightly shorter in width than the centre doorway. (Not really visible on the image)

All help will be greatly appreciated.

Thanks,
Brandon

Apologies, my brain isn't working well today. I think its the heat. >_<

The problem is pretty obvious when looking at the picture, but the skirting board isn't meeting the floor.

I thought about extruding the base of the board to bring it down to where I want it to go but then its too wide and looks strange compared to the skirting boards on a flat level.

I also can't change the stairs because I have them at the dimensions I need.
Whats wrong?!