What are these gray borders? They appear when I set up a scene. However when I want to continue working on the model they stay there. Can't figure out hoe to disable it and and am having to restart to remove them.
please, someone must know
What are these gray borders? They appear when I set up a scene. However when I want to continue working on the model they stay there. Can't figure out hoe to disable it and and am having to restart to remove them.
please, someone must know
Thanks Giles
I have seen that but it'a work project and son't think they are going to want to spend any money, I'm not even on pro. Was hoping for a free script
Thanks Cotty
I tried that, seems to work ok.
Hi,
I have a Solar Farm that I am working on. it is a huge site covering 26 hectares. The entire site has a 2m high perimeter fence which I have modeled a section of. My issue is how do I repeat this fence component along the perimeter of the site. The terrain has been modeled from surveyed contour data so the fence does not run along a flat surface.
I have tried using component stringer however the fence has to be 2m high and when scaling is set to none there are a lot of gaps. I have also tried copy along path which doesn't seem to work at all as the scale and angles go completely out of sync.
At the moment I am having to resort to just copy each section and then adjusting angle/height individually however this is just too time consuming.
Any ideas?
Thanks
Alex
Hi, newbie here.
I have a solar farm which I am working on. I have modeled the terrain from contour data and used smart drop to place each individual solar panel module onto the terrain. I have marked 5 viewpoint locations around the model at their correct AOD height. I now want to export the model fro these viewpoints and place it into the panoramic photographs of the existing site. Some of the panoramas are almost 190degrees. My question is how do I export the model to achieve this? I have used position camera and taken a number of scenes and tried stitching them together in photoshop however the exported jpegs dont seem to match. Any ideas?
thanks
Alex