Is there some point clouds plugin better that "Undet"? (Undet is full of bugs ,and You must pay for that a lot) .
Thanks for some advice.
adam

Hi All
Is there some solusion to avoid the situations, when the circles or curves or arcs automatically changes to segments? And why does it happen? After that, when You use the push/pull tool, the profiles looks like hatched.

It happens very often when You make some operation with solids, (cutting the arcs or circles, making the group and exploding them or just copying such a elements)
It looks like:
http://wstaw.org/m/2016/12/08/LINES.jpg
and
http://wstaw.org/w/4geN/

Thank You in advance for some help and advices.
Adam

T h a n k Y o u !!!

Hi All.

Can You advise me how to change the standard views (Top, bottom, front, back, left, right etc) in my model?
I've tried to change the axes position and rotate them, but the views are still the same!
I've tried also to use the "Solar-North" plugin to change the north direction angle , and this is also has no influence for standard views planes.
So why the views are still the same? Why the program doesn't change them when You change the axes angle?

I have also similar question . How to view the section cutting plan view in isometric mode, ("front view"), if the section plane is not parallel to the standard view orientation?
Is there some method, which shows You front view of your section when it is not parallel to standard views directions???

How to see that? How to do that?

Thank You in advance for some advice.
Adam

Can I convert any popular cloud files like pts, xyz, pod etc to rwp trimble files? Where can I find some example of trimble rwp file? Regards. Adam