I have 2 components I modeled in 2 separate files. One a cylinder and the other a platter that needs to stack inside the cylinder multiple copies. The cylinder was modeled in a horizontal axis and the platter in a vertical axis. For some unknown reason the cylinder appears to be slightly off axis (3 or 4 degrees)in addition to being 90 degrees off axis to the platter.
The tasks I cannot find a precise way of accomplishing are:
The cylinder -
- remove the off axis tilt accurately
- Rotate the cylinder 90 degrees and center the hollow cylinder on its vertical axis.
- Move the cylinder's then centered vertical axis onto the platters already centered vertical axis so as to slide the cylinder over the platter.
Have become very familiar with the "undo" command in the past several hours.