Two Radius intersecting at 90 degrees

Gaieus

Dylan, see the thread about Camtasia (free now) here.

dylan

How did I miss that thread!

Ok, well if you follow the link Gaieus posted, it says the offer has expired on the webpage.
Ignore it!
Just click on the link to download the program then the link to get your serial. On this page it tells you the offer ends 7th January.

2 days to grab it!

Gidon Yuval

Am I too late to offer this little tut?

Testing2.skp

Gaieus

Yes, Gidon, too late. (Of course when someone is cooking goulash on Sabbath! )

See this post with this attachment.

Julius

check out Debut, it's better tahn autoscreenrecorder purchasable version and it's free. (when installing it will ask you if you want to install any other program, they're all trial versions but "Prism" wich is free and is a good video format converter).

gata

On the original model, that 'stubborn' face would have pushed through if you used Push/Pull+Ctrl (PC).

natemclain

I was just able to get back on the PC and play with this some more.
I have a new problem...
Just so you know this is a leg for furniture.
I can make the leg by hand, but want to share it with others online.

I have the profile that I want to push to the back side on both faces of the model.

Can someone explain the process to accomplish this?
Should I push/pull the curved profile back before I create the cove on the 2 faces that everyone has shown?

All the suggestions have been very helpful! And I have learned allot with this excercise.

BTW I have attached an actual picture of the leg that I'm trying to model.

TIA

Nate

TestingAgain.skp

Gaieus

Hi Nate,

Have a look at Gidon's "Cabriole leg" tutorial in this thread to get some ideas.
This leg of yours have some similarities and you can easily adapt the workflow.