The Nadesico A
-
Aft indentation created. Will add the weird vent/fin/grill things next.
-
Top rear grill thing complete. Made as a separate component, one side only, then duplicated. I'll stop here and double check my proportions. I already see the lower hull is too wide at same location as the top grills.
-
Back to this in a few days. Doing some brain salad surgery on my laptop. Much needed maintenance.
-
Rear grill things completed.
-
Forward nacelle struts cleaned up. Intersected main hull and then deleted excess lines that were inside the main hull and filled in the faces. It's not "perfect", but upper and lower pods will hide most of the details later. But is IS flush with the hull now.
-
Progress to date.
-
Great progress
Looking forward to seeing it in a render. -
Thanks tuna.
-
Go sidetracked on the artist studio render. But I learned a lot from it!
Let's see, what part to model next? The rear engines I think...
-
First rough block of the rear engines.
Same technique as before. One component, replicated 4 times for each pod. I'll add the missing gap sections after I finalize the main pods.
Now for the fiddling... first I'll get the outlines and mass shaped up.
-
Thanks tuna. Thanks L i am.
-
2 more views.
-
Rear engines shaping up somewhat.
Just a reminder that everything to date is still just blocking out. Even the front nacelles. I just did a little extra on those to give me an idea of what I need to do once the blocking was done, but even they need more attention. Once the mass shapes are good, I will go back and smooth everything out with more faces. So there are many more stages to go after the block-outs are done.
Months I tell you!
-
Forgot to mention I will be using Curviloft for final cleanup and smoothing.
I will be sure to show how I use it. I've already tested it and it's going to work beautifully.
But I have to finish the block-out shapes first. So it will be some time before I get to that stage.
-
Want one. Hasda be would never be the same but, I could live with that very easily.......
-
@mike amos said:
:thumb:
Want one. Hasda be would never be the same but, I could live with that very easily.......
-
Excellent progress
Funny side note…. when I see the title of your post my brain says Nabisco and I start looking for the cookies -
Thanks tuna!
LOL, yeah I had the same problem when I started watching the show.
More engine pod updates.
-
Correctly positioned the engine pods. Made basic pod struts as component, then used strut for equal placement.
-
Geometry clean up to make the surface flat for the side pod thing to come.
Advertisement