Help with wrapping around object

ely862me

You should draw that shape on a horizontal plane, then push it down and intersect it with the dome.
You can do the same for the walls. Then group the intersections and play further rounding the corners and giving it thickness .

Kashaki

Hi Elisei,

Thanks for your reply. But what do you mean with 'draw it on a horizontal plane and then push it down"? Because that knot shape is actually 'hugging' the dome shape but it is not hugging the blocked shape. It is coming from the dome in a curve and bending around the block.

I have attached the file is it maybe possible to show what you mean?

Thanks in advance,

Kashaki

Hak_shape2.skp

ely862me

Something like this. You draw the top shapes,then the sides. In a way that look like they are connected of course.

Kashaki

Hi Elisei,

Thanks again, but this means that it will subtract it from the dome. I do not want to substract it. I want to make a new shape wrapping all around the rectangle and dome in a "knot" kindaway. It is difficult to explain but it is something like the picture attached. But then wrapping it around the rectangle and dome. Actually laying (in contact with) just above the dome but when coming down from the sides of the rectangle, not touching the rectangle, but coming in a curve following the curves of the dome and then bending around it.

Thanks again,

Kashaki

ely862me

You don't need to subtract it from the dome, you can simply make a copy of your shapes and work with them then move the resulted geometry over your actual building.

pbacot

I like Elisei idea to give you the form the shape follows on the dome but then you must continue with giving it thickness and extending beyond the dome, which is a "Hands-on" modeling job, which you may have to build bit by bit. You could continue the ribbons, making paths (curves) defining the "edges" of the ribbon and Extrude Tools to fill in a shape between those curves.