Notched Box Plugin

Jim · 15 Aug 2010, 15:21

There is a slot and tab plugin also, which may be helpful.

http://forums.sketchucation.com/viewtopic.php?t=28616

Are you looking for a more specific solution to generate these boxes?

cosycat · 16 Aug 2010, 11:51

Do you mean a dovetail joint ? if so, then this is a useful plugin

(www.finewoodworking.com)

direct link
http://thewoodenscrew.blogspot.com/

Dave R · 16 Aug 2010, 12:57

After reading cosycat's reply, I am wondering if CNC Paul is referring to a box joined at the corners with box joints as shown on the left side of this box.

If that is the case, the plugin cosycat mentioned would work. There's a better one albeit not free. See here . To make the box joint instead of a dovetail joint with either plugin, set the angle to 0.

CNC Paul · 17 Aug 2010, 06:03

Hi Guys,

Thanks for all your help, I think I need to explain a bit more...The plugin creates a 6 sided box with all edges notched as the picture, it also lays the panels out flat.

Thanks

Paul

Dave R · 17 Aug 2010, 10:14

They're just wide box joints. The dovetail plugins mentioned would certainly do those notches. As to laying the pieces out flat, I'm not familiar with one that would that part. I assume your next step after alying them out flat is creating the tool paths to make the parts?

CNC Paul · 17 Aug 2010, 20:52

@dave r said:

They're just wide box joints. The dovetail plugins mentioned would certainly do those notches. As to laying the pieces out flat, I'm not familiar with one that would that part. I assume your next step after alying them out flat is creating the tool paths to make the parts?

Yes

sorry for the long winded reply

Dave R · 17 Aug 2010, 21:08

Paul, no one could accuse you of being long-winded.

So if you are able to speed up drawing the tabs or box joints, would manually laying the parts out flat be a problem?

kyyu · 18 Aug 2010, 11:04

Not a plugin, but there is a free software that does generate and lays out the parts for the box. The output is pdf. I did convert their sample pdf to dxf a while back. And imported it into sketchup. One thing to note is that, it's not layed out like you would expect, so hard to figure out when trying to actually assemble the box.

301 Moved Permanently

(rahulbotics.com)

Jim · 18 Aug 2010, 14:40

Thanks kyuu, that's a nice little program.

CNC Paul · 18 Aug 2010, 16:02

Kyyu,

Many thanks for the link, that is perfect.

CNC Paul · 18 Aug 2010, 16:14

@dave r said:

Paul, no one could accuse you of being long-winded.

So if you are able to speed up drawing the tabs or box joints, would manually laying the parts out flat be a problem?

LOL,

No, not really, I just thought it would quicker to output the parts, nest them and the cut the parts.