Seamless tiling

Epix3D

Trying to make a seamless texture. When used in SketchUp 2025 it tiles wrong.
Anybody have a solution?

TIG

The joints need to be whole or a half [or zero]. At the moment the short lengths of joint don't add up to a whole joint, hence the oddity when the texture repeats.

Dave R · 4 Jan 2025, 13:08

It tiles correctly in SketchUp for the image you have supplied.

Illustrating what TIG described: I cropped your image down to eliminate the partial tiles on the sides. The cropped image is shown imported as an image on the left and as a material on the larger face to the right.

panixia

@Dave-R I would recommend to crop such kind of "self repeating" texture into a single tile, so that it weights about 50 times less for the same quality.
Unless you need to add some variation on top of that, of course.

Dave R

@panixia that's fine. I was simply demonstrating what it would take for the OP to use the texture image they shared.