Problem with 100 sides circle and fallow me tool
-
I have trouble to make sphere with 100 sides circle and fallow-me tool!
I always get unfinished sphere.... no top!... top side of sphere is always open...
What to do? -
I assume you mean the Follow Me tool. You're working at too small of a size.
Try scaling your model up by a factor of 100 or even 1000 before running Follow Me.
-
I work with piping. I make it a point to always have the number of segments to evenly divided in to whole degrees. So as an example, I use for extra fine detail, 360 segments for 360 degrees, 1 seg/per/deg, 180, 2 seg/per/deg. Also as Dave indicates, scaling up always help.
If I going to divide a pipe segment into to some other degrees, I always make sure the division is made at full degrees.
Just my two cents worth.
Ken
-
SketchUp's built-in tolerance is 1/1000"
If your initial circle's segment length results in FollowMe geometry edges of shorter than 1/1000", then they won't get made - because SketchUp assumes the two ends are coincident and so skips on.
Then any dependent facets also get omitted etc...This occurs in any operation making new geometry - like the native FollowMe, Intersect etc and any similar Plugins...
As was said before... Scale up temporarily to avoid these issues.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better đź’—
Register Login
Advertisement