[REQ] Ctrl+Push pull without internal faces
-
Then I think it is best to ask Fredo if his PushPull suite would have such an option.
He just about does on toggle of CTRL except he create the face and loop
-
But it does it already Rich.
- Normal push pull
- Erase original faces
- Faces on contours
With all the bells and whistles that also come with it...
-
You had me excited for a minute... I was hoping for a version that doesn't flip the original push face to a backface. When I create walls and such I always get backfaces on the outside of and on top of walls.
-
@krisidious said:
When I create walls and such I always get backfaces on the outside of and on top of walls.
You don't have to create that problem for yourself.
-
-
I don't really see your point Dave. It's not really up/normal that's my problem, but negative push from the front. I pull all my walls up and then push back down for header and door/widow height. I've learned to pull doors and windows up separately to stop this from happening but it increases workflow.
-
-
That's weird?
My reply posted twice with a three hour interval?
-
Kris, Push/Pull is doing what it should in those cases. Get rid of the floor inside the walls and it won't give you the reversed faces.
I thought you and I went through this a few years back and had you had it all sorted out.
-
You're thinking of the wrong face. The top face extruding downwards. it's already a front face and when I extrude it (push/pull) it downwards it flips the top face to a back face.
-
My point is that any face should retain its front/back status when push pulled.
Advertisement