Mech Head
-
haha.
I was reminded of this as they sell them by my house...http://www.xhaletobacco.com/images/gas-mask-bong.jpg
-
Funny liam.
pbacot, thanks.
I used a 3DS Max training file as reference in making the face. Focusing of course only on the area I wanted. I blocked it out much like you see here then ran Artisan's Subdivide and Smooth for a couple iterations. After that I just started playing with shapes, extrusions etc. Another couple tools I have been utilizing (practicing with) are Selection Tools and Vertex Tools.
-
@boofredlay said:
Funny liam.
pbacot, thanks.
I used a 3DS Max training file as reference in making the face. Focusing of course only on the area I wanted. I blocked it out much like you see here then ran Artisan's Subdivide and Smooth for a couple iterations. After that I just started playing with shapes, extrusions etc. Another couple tools I have been utilizing (practicing with) are Selection Tools and Vertex Tools.Do you have an image of the head when you had finished blocking out and then proceeded to use SD&S?
-
No but I got it to look pretty close to the one in the above image, bottom right, without the ears, mouth, neck or back of the head (triangulated of course).
-
@boofredlay said:
No but I got it to look pretty close to the one in the above image, bottom right, without the ears, mouth, neck or back of the head (triangulated of course).
Oh nice, I bet that took a while!
-
Not too bad. Just a bunch of stitching and manipulating vertices. Plus I only had to do half
-
There are a bunch of videos out there but this one helped me as well. Using Vertex tools it makes it much less painful.
-
Bit creepy but looks nice.
-
I had some time to play a bit with this the past couple weeks or so. Just now getting around to saving images. Not sure really where this is going but it is fun.
-
I had forgotten all about this one.
Looks good. Sometimes it's just fun top play around.
Advertisement