Trim and extend in sketch up

architectfkh · 13 Apr 2012, 02:26

Hi Every one
I would like to know is there any similar tools like trim and extend in autocad available in sketch up?
thx a lot in advance

TIG · 13 Apr 2012, 09:38

There are several.

My 2dTools set includes a 'Fillet' tool.
This extends/trims two picked lines to the fillet arc.
If the fillet radius is set to 0 [the initial default] then it acts like 'trim/extend'.
There is also a toggle to 'chamfer' in the tool.

The 2dTools set also includes an 'Adjust' tool.
This also works somewhat like 'trim/extend', but this tool allows you to pick 'sets' of edges to 'adjust' to and then 'sets' of edges to be adjusted...

architectfkh · 13 Apr 2012, 23:05

thank you very much for the response friend