Twist in a surface...i dont get it right.
-
Hi Guys, i have a question to curved surfaces?! I use the follow me tool to construct a surface winding between two lines. But now i habe three lines and sketchup ignores the third one. Its quiet difficult to tell. Have a look by yourself,... and thanks for reading.
First picture is a look from behind above, second from above direct. You see the emty bow? The surface should follow all three lines...like a sail over a frame.
Keksschredder
cooky-shredder
-
Hi,
Can you upload the file to see more clearly? It's hard to make out what you're trying to achieve
-
ok i attached it. thx.
-
Try my ExtrudeEdgesByRail tool - it's in the Extrusion Tools Zipped set...
You select the profile, and then the two rails - in this case there's not 'melding-profile' so you select the profile again..
-
Thats what i was looking for. Thank you very much Tig.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
Advertisement