Drawing round objects

merc · 22 Feb 2010, 16:09

I hope I can explain this.
I can not seem to be able to draw a circle--pull it to make a cylinder--then reduce the diameter-pull it some more and increase the diameter.
The final object should look like a pedestal,with a bowl on top.
How do you do that?
thanks

TIG · 22 Feb 2010, 16:20

Something like this ?
Use the PushPull +Ctrl key to split then Scale about center by +Ctrl and Offset top face to keep it flast as tanle top etc...

merc · 22 Feb 2010, 18:14

Thanks TIG
good instruction too.
I followed each step and drew that.
thanks
How do I make the bowl round, without straight edges?

Jean Lemire · 22 Feb 2010, 19:19

Hi folks.

And a few ideas on how to do it a bit faster.

Bowl on pedestal.skp