Hole in a bucket
-
More in exploring with holes. Eventually going to get up to combining this with the dynamic hole to make - you guessed it, a dynamic flange (with bolt holes!)
Let me know what you think.
Mark
-
Hi Mark,
I've a stupid question based on this
Why is the DC 1" x 1" x 6.5"?
I've 1" hole at 6" so bar is 6.5" to accommodate hole diameter. The bar is 1" thick but why is it 1" wide? How can i change width of bar so hole could be off centre?
Other than that, good work
-
@unknownuser said:
Hi Mark,
I've a stupid question based on this
[attachment=0:tpgn65yn]<!-- ia0 -->The Bucket List.jpg<!-- ia0 -->[/attachment:tpgn65yn]
Why is the DC 1" x 1" x 6.5"?
I've 1" hole at 6" so bar is 6.5" to accommodate hole diameter. The bar is 1" thick but why is it 1" wide? How can i change width of bar so hole could be off centre?
Other than that, good work
Oh boy... I programed it so the hole will always be on-center in the Y and off-center in the X, because that's what my flange needed. I could probably switch that out... gimmie a day. I've got a bit of work to do now that lunch break is over...
-
-
Hi Markozeta,
My previous post wasn't a request just a query, but thanks for taking the time to actually sort it out.
It works brilliantly, well done.
Now to make a square peg to fit in the round hole
Advertisement