Hole in a bucket
-
More in exploring with holes. Eventually going to get up to combining this with the dynamic hole to make - you guessed it, a dynamic flange (with bolt holes!)
Let me know what you think.
Mark
-
Hi Mark,
I've a stupid question based on this
Why is the DC 1" x 1" x 6.5"?
I've 1" hole at 6" so bar is 6.5" to accommodate hole diameter. The bar is 1" thick but why is it 1" wide? How can i change width of bar so hole could be off centre?
Other than that, good work
-
@unknownuser said:
Hi Mark,
I've a stupid question based on this
[attachment=0:tpgn65yn]<!-- ia0 -->The Bucket List.jpg<!-- ia0 -->[/attachment:tpgn65yn]
Why is the DC 1" x 1" x 6.5"?
I've 1" hole at 6" so bar is 6.5" to accommodate hole diameter. The bar is 1" thick but why is it 1" wide? How can i change width of bar so hole could be off centre?
Other than that, good work
Oh boy... I programed it so the hole will always be on-center in the Y and off-center in the X, because that's what my flange needed. I could probably switch that out... gimmie a day. I've got a bit of work to do now that lunch break is over...
-
-
Hi Markozeta,
My previous post wasn't a request just a query, but thanks for taking the time to actually sort it out.
It works brilliantly, well done.
Now to make a square peg to fit in the round hole
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
Advertisement