I tried that, and I got one side, but the other was not working. Do you think there is any other way that it can be done. If not do you think I should leave it like it is.

OK. I have one more question. Not I have the whole thing completed, but I want to cut out the triangles that are on the blade. Is there any way to do that.

Here is my product so far. I am pretty satisfied.

This is my final, or almost final, product. I am very satisfied.

I am trying to make a 3d model of Gimli's Battle Axe from Lord of The Rings. I need the blade part on both ends. This is a link to the image. Keep in mind I only need to blade.

http://theexcaliber.com/library/UC1397ABNB20on20plaquebataxGimli.jpg

I am trying to make a model of an axe. I can not figure out how to make the edge of the blade where it is supposed to be sharp. How is that done?