Hi,

I'm using Sketchup 7.1 with Sketchy Pysics 3.1 with dutch language.

I cannot find something similar like 'worldscale' or 'readback geometry'.

I suppose menu's topology are identical between language versions.
Can you tell what menu/submenu number from left/top is involved?

Thanks

Henk

Hi,

I created a disk with a central hinge. Near the border of the disk, on the disk, there is a second hinge connected to some beam in the neighbourhood of the disk. The central hinge is given a small acceleration through the UI.

It depends on the length of the beam if the system is running or stuck.

What makes the length of the beam being of influence on the system?

Thanks,

Henk

Hi Gaieus,

I found the cause of the problem.

I placed several electronical components on a separate layer which I do not want to disturb my PCB layer so I place all components 1/100 of a millimeter above the PCB-face. Some components in the component-layer however where placed on the PCB-face, so when intersecting these component intersections with the PCB layer appeared on the PCB layer.

Lifting all components 1/100 of a mm solved the problem.

Thanks anyway.

Henk

Hi,

My drawing has grown quite large (>20MB) although I don't know if that's a factor.

I have drawn a printed circuit board (PCB) with holes and tracks.
I selected a few lines and faces and execute a 'Intersect with Model'.
Suddenly al kinds of old ever-used (and I thought, deleted)lines and rectangles appear on the PCB face.
If I delete them, save my file, reopen my file, execute a same kind of 'Intersect' all removed lines re-appear.
That same thing happens when moving those lines to another layer, remove that layer, save/reload that file and 'Intersect' again.

If I remove one of these rectangle lines from the PCB face then still that space inside the removed rectangle is a separate face in the PCB face. No hidden lines are there that separates this inner-rectangle space from the remaining PCB space. I can delete that inner-rectangle leaving a hole in my PCB.

Is this some bug, or hidden layer, or do I mis something?

Thanks

Henk